Samsung NC241 User Manual page 36

2
Using "PCoIP"
Secondary DNS Server

The secondary DNS IP address of the device. This field is optional.
If the DNS server IP address is configured using the Connection Manager, the address may be set
as an FQDN instead of an IP address.
Domain Name

The domain name used (e.g., 'domain.local'). This field is optional.
This field specifies the host or domain of the client.
FQDN

The Fully Qualified Domain Name for the host or client. The default value is pcoip-host-<MAC> or
pcoipportal-<MAC> where <MAC> is the MAC address of the host or client.
The domain name is appended if used (e.g., pcoip-host-<MAC>.domain.local).
This field is read-only on this page.
Ethernet Mode

Lets you configure the Ethernet mode of the host or client as:
Auto

100 Mbps Full-Duplex

10 Mbps Full-Duplex

When you choose
message will appear.
"Warning: When Auto-Negotiation is disabled on the PCoIP device, it must also be disabled on the
switch. Additionally, the PCoIP device and switch must be configured to use the same speed and
duplex parameters. Different parameters may result in a loss of network connectivity.
Are you sure you want to continue?" Click
You should always set the
100 Mbps Full-duplex
operate at
Mode may result in the network operating at half-duplex which is not supported by the PCoIP
protocol. The session will be severely degraded and eventually dropped.
Enable 802.1X

should be enabled and security-authenticated devices can only be used.
If Enable 802.1X Security
settings.
TLS (Transport Layer Security) is only supported as an authentication protocol at present.
Identity: Enter the product ID that will be used on the network.

Client Certificate: Select a certificate uploaded from the Certificate Upload page.

10 Mbps Full-Duplex or
Ethernet Mode
when the other network equipment (i.e., switch) is also configured to
10 Mbps Full-Duplex or 100 Mbps
Security: If the connected network supports 802.1x,
is enabled, configure the Authentication,
100 Mbps Full-Duplex and then click Apply, a warning
OK to change the parameter.
to Auto and only use 10 Mbps Full-Duplex
Full-duplex. An improperly configured Ethernet
Identity
or
Enable 802.1X Security
and Client Certificate
2 Using "PCoIP"
36