Setting The End Time - Bosch CMG633B.1B Instruction Manual

Time-setting options
en
The value is applied after a few seconds, or you can
touch the field twice. The cooking time is shown
in the display under the operating mode and
temperature or level.
Press the Start/Stop button to start.
4.
The cooking time counts down in the display.
The appliance begins to heat up.
Once the cooking time has elapsed, an audible signal
sounds. The appliance stops heating up. The cooking
time 00 m 00 s is shown in the display.
You can use the field to set another cooking time, or
use the Start/Stop button to continue the operation
without a cooking time.
When your dish is ready, use the
switch off the appliance.
Changing and cancelling
To change the cooking time, touch the
cooking time is highlighted white and can be changed
using the rotary selector. Use the
change.
If you want to cancel the cooking time, reset the
cooking time to zero. After the change has been
applied, you can continue the operation without a
cooking time using the

Setting the end time

You can delay the time that the cooking time ends. You
can, for example, put your dish in the cooking
compartment in the morning and set the cooking time
so that it is ready at lunch time.
Notes
Ensure that food is not left in the cooking
compartment for too long as it may spoil.
Do not adjust the end time once the operation has
started. The cooking result would no longer be
satisfactory.
Setting
The end of the cooking time can be delayed by a
maximum of 23 hours and 59 minutes.
Example in the picture: The set cooking time is 45
minutes and you want the dish to be ready at 12.00
p.m.
Set the operating mode and temperature or level.
1.
Set the cooking time.
2.
16
On/Off button to
field. The
field to accept the
Start/Stop button.
Before starting, touch the
3.
The end time is highlighted in white in the display.
Turn the rotary selector to set a later end time.
4.
The value is applied after a few seconds, or you can
touch the field again. The end time is shown in
the display under the operating mode and
temperature or level.
Press the Start/Stop button to start.
5.
The time at which the appliance will start is shown in
the display.
The appliance is in standby mode. When the appliance
starts, the cooking time counts down in the display.
Once the cooking time has elapsed, an audible signal
sounds. The appliance stops heating up. The cooking
time 00 m 00 s is shown in the display.
You can use the field to set another cooking time, or
use the Start/Stop button to continue the operation
without a cooking time.
When your dish is ready, use the
switch off the appliance.
Changing and cancelling
To change the end time, interrupt the operation using
the Start/Stop button and then touch the
twice. The end time is highlighted white and can be
changed using the rotary selector. Continue the
operation using the Start/Stop button.
If you want to cancel the end time, reset the end time to
zero. You can start the set cooking time immediately
using the Start/Stop button.
The end time can only be changed if the cooking
Note:
time has not elapsed. Otherwise the cooking result
would no longer be satisfactory.
field once again.
On/Off button to
field