Advertisement
Voyager Quadcopter
Getting Started Guide
1.
UNPACK
Unpack the Cocoon Voyager Quadcopter from the packaging and check you have all the components:
•
1 x Voyager Quadcopter
•
1 x Remote Control
•
4 x Replacement Propellor Blades
•
4 x Blade Guards
•
1 x Screwdriver
2.
CHARGE BATTERY
1. Switch the Voyager Quadcopter off and open the battery cover.
2. Pull the battery wire out of the power port and remove battery.
3. Plug the battery wire into the smaller end of the USB charging cable.
4. Connect USB cable to an active USB port.
Note: A full charge will take roughly 75 minutes
3.
INSERT BATTERIES
1. Remove the screw from the back of the remote control and remove the battery cover.
2. Insert 4 x AA batteries (taking note of polarity) and replace battery cover.
3. Reverse the steps in Section 2 to reconnect the battery to the Voyager Quadcopter.
After Sales Support
1300 663 907
www.winplus.com.au
•
1 x USB Charging Cable
•
4 x ActivEnergy AA Batteries
•
1 x Instruction Manual
•
1 x Getting Started Guide
•
1 x Warranty Card
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Cocoon Voyager
Summary of Contents for Cocoon Voyager
- Page 1 Voyager Quadcopter Getting Started Guide UNPACK Unpack the Cocoon Voyager Quadcopter from the packaging and check you have all the components: • 1 x Voyager Quadcopter • 1 x USB Charging Cable • 1 x Remote Control • 4 x ActivEnergy AA Batteries •...
- Page 2 Winplus Australasia does not take any responsibility if local rules and regulations are not followed. Note: The best way to know which direction the Voyager quadcopter is facing is by the coloured LEDs on it’s wings. The red lights will face forwards, while the green lights face backwards. Always keep the Voyager Quadcopter in direct line of sight.
Need help?
Do you have a question about the Voyager and is the answer not in the manual?
Questions and answers