Table of Contents
Advertisement
Quick Links
®
INSTRUCTION MANUAL
WARNING
Please fully read and understand this manual and the operation and all
safety aspects required of you for the safe operation of this product.
Before use, if you feel this product is not for you please return it to your
place of purchase.
Heli-Max products are to be used by ages 14 and over.
Manual Specifications and Description Changes
The instruction manual, warranties and other associated documentation are
subject to change without notice. Hobbico assumes no responsibility for
inadvertent errors to this manual.
© 2015 Heli-Max, a Hobbico company.
HMXE0864 v1.1
Advertisement
Table of Contents
Related Manuals for Heli-Max Voltage 500 3D
Summary of Contents for Heli-Max Voltage 500 3D
- Page 1 Before use, if you feel this product is not for you please return it to your place of purchase. Heli-Max products are to be used by ages 14 and over. Manual Specifications and Description Changes The instruction manual, warranties and other associated documentation are subject to change without notice.
- Page 2 ® Thank you for purchasing the Helimax Voltage 500 3D. We want the time you spend with your new R/C quadcopter to be fun and successful, so please read the entire manual before beginning setup. If for any reason you think this R/C model is not for you, return it to the dealer immediately.
- Page 3 SETUP The Voltage 500 3D does not need any assembly. All the non-adjustable bolts have been set to the proper torque and have thread locking compound applied to keep them secure. The tension of bolts that clamp the booms should be...
-
Page 4: Flight Controller
Before testing your setup, remove the props from the motors. Turn on the transmitter and connect the battery to the Voltage 500 3D. Use the LED codes on the Flight Controller to verify that Gear switch can select the Motor Disarm mode and the two flight modes. - Page 5 The motors can be armed and operated while the flight controller is connected to the Voltage 3D app. Turn on the transmitter and connect a flight battery to the Voltage 500 3D. When you see a steady green LED, connect the USB cable to your computer and the USB port on the flight controller.
- Page 6 FACTORY DEFAULT GYRO SETTINGS These settings were Aileron/Elevator Gain tested with 3S and Aileron/Elevator Damping 4S batteries. Rudder Gain TIP: While removing the USB cable from the flight controller, push down on the controller to keep it from moving. If any of the o-rings on the mounting posts are lost, the controller may come loose in flight.
- Page 7 MOTOR ARMING Set the transmitter so the motors are disarmed. Place the Voltage 3D on a level surface and connect the battery. If the quad is not level when powered up, it may drift when the sticks are centered. After the speed controls have chimed twice, pause, and then chime again, select the desired flight mode and arm the motors if the transmitter is using throttle hold.
-
Page 8: Exploded View
2 HMXE2401 Upper Frame 3 HMXE2403 CF Booms (4) 4 HMXG2405 Brushless Motor 5 HMXE2407 8.9" 3D Prop Set (4) 6 HMXM2410 Voltage 500 3D Flight Controller Set 7 HMXE2412 CNC Tube Holder 19 mm 8 HMXE2413 Voltage 500 3D Red Body...
Need help?
Do you have a question about the Voltage 500 3D and is the answer not in the manual?
Questions and answers