Table of Contents
Advertisement
Getting started
Belt clip & optional headset
Install belt clip as shown below if desired.
Snap belt clip
into the notches
on both sides of
handset.
For hands-free telephone conversations, use any industry standard 2.5 mm headset
(purchased separately). For best results, use an AT&T 2.5 mm headset. To
order an AT&T 2.5 mm headset, visit our website at www.telephones.att.com
or call (800) 222-3; in Canada, call (866) 288-4268.
TONE
MUTE
REDIAL
DELETE
PAUSE
Plug 2.5 mm headset into
the jack on the side of hand-
set (beneath small rubber
cap).
To release belt clip
from handset, lift one
side of the belt clip
out of the notch.
NOTE: If the sound quality of
the headset is not good, try unplug-
ging it, and firmly plugging it in again.
0
Advertisement
Table of Contents
