Sharp CD-BA2010H Service Manual page 17

EON summary notice for reference
1. EON-TI/PTY EON stand-by can be set, only when EON ind. Lights up.
While EON ind. Goes out (NO EON STATION), EON stand-by can't be set.
If the EON button is pressed, then "NO EON" is indication the display.
Even if switch back ON → TN station continue to keep EON stand-by.
2. EON-TI/PTY
Don't switch TN → ON during TN broadcast TA. (same item)
3. EON-TI
4. EON-TI/PTY EON can be cancelled during receiving ON station by pressing EON button if necessary and switch back ON→TN.
5. EON-TI/PTY EON stand-by is perfectly cancelled (cleared) by pressing EON button 2 times during stand-by or power OFF
or Tun Up/Down or change band or recall pre-set CH.
6. EON-TI/PTY After setting EON stand-by, stand-by items can be confirmed by pressing EON button one time.
7. EON-TI/PTY EON button function: • EON setting
8. EON-TI/PTY After setting EON-TI and EON-PTY stand-by, if when EON data is not transmitted, EON ind goes out and
EON stand-by is automatically cancelled display "NO EON".
9. EON-TI EON-TI stand-by can't be set. When TP=0,TA=0 (TN) even if EON ind. Lights up and the EON button is
pressed then "NO TI" is indication the display.
Don't switch TN → ON during TN broadcast same specified PTY. (same item of PTY)
10. EON-PTY
Switch TN→ON → TN station one cycle.
11. EON-TI/PTY
Never switch TN → ON1 → ON2 → Other net to other net station.
After switch TN → ON station. When ON station is NO RDS, NO signal, TA=OFF or different PTY items.
12. EON-TI/PTY
The receiver switch back ON → TN displaying "NO READY".
During receive ON station. When ON station become to be NO RDS, NO signal, TA=ON to OFF or different
PTY item, The receiver switch back ON → TN.
Switch TN → ON in case of 2 more stations exist, comparing field strength and switch to the strongest station,
13. EON-TI/PTY
if these signals are same strength, switch to the first previous station.
If same frequency as AF'Sexists in the preset memory, then switch TN → ON (preset memory station) straight.
In case of exist 2 more preset memories of AF'S,then switch to the preset CH which taken in EON DATA
first, also in this case no concern to field strength.
Even if switch TN → ON preset memory straight, that ON station is very weak signal, then search another
AF'S (ON) station comparing field strength and switch to the strongest station as a result. Of all stations of
AF'S are very weak or no good condition, then, switch back ON → TN automatically display "NO READY".
14. EON-TI/PTY No linkage volume, power ON/OFF, and switch function.
Traffic Programme code
(TP)
OFF
OFF
ON
ON
• Confirm stand-by items
• Cancel (ON→TN)
• EON clear cancel (2 times)
Traffic Announcement code
(TA)
OFF
ON
OFF
ON
This programme does not carry traffic announcements nor does
it refer, via EON, to a programme that does.
This programmecarries EON information about another
programme which gives traffic information.
This programme carries traffic announcements but none are
being broadcast at present and may also carry EON information
about other traffic announcements.
A traffic announcement is being broadcast on this programme
at present.
– 17 –
CD-BA2010H
Applications