Retainer Replacement; Stylized Rewind Starter (Tvs, Hm, Tvm, Tvxl), And Stamped Steel Starter (Hm, Vm, Tvm, Tvxl) - Tecumseh ECV105 Technician's Handbook

Standard rope lengths
54" (16.5 meters) standard stamped steel starter
61" (18.6 meters) vertical pull - horizontal engagement
type
65" (20 meters) vertical pull - vertical engagement
type
85" (26 meters) extended handlebar rope start
(compliance)
Check the old rope for the right length for the application.
Some applications require longer lengths. The rope ends
should be cauterized by burning with a match and wiping
the rope end with a cloth while hot.
Rope replacement can be done without the starter being
disassembled on vertical pull starters that have "V"
notches in the bracket. Use the following procedure for
rope replacement.
1. Remove the starter assembly from the engine.
2. Turn the pulley until the staple in the pulley lines up
with the "V" notch. Pry out the staple with a small
screwdriver and remove the original rope (diag. 3).
3. Turn the pulley counterclockwise to fully wind the
starter return spring until tight. Allow the pulley to
unwind until the hole in the pulley lines up with the
"V" notch.
4. Hold the pulley in this position and feed the new rope
through the hole and tie a left-handed knot on the
rope end. Make sure the rope and knot do not
protrude from the knot cavity and bind the pulley
rotation.

RETAINER REPLACEMENT

1. Remove the starter handle if the retainer is a complete
circle design. Remove the staple and old retainer.
2. Slide the rope retainer into the proper position and
insert the staple using a pliers.
3. Install the starter handle and tie a left hand knot to
secure the handle.
STYLIZED REWIND STARTER (TVS, HM, TVM,
TVXL), AND STAMPED STEEL STARTER (HM,
VM, TVM, TVXL)
Disassembly Procedure
1. After removing the rewind assembly from the engine
blower housing, release the tension on the rewind
spring. This can be done by removing the starter
handle and carefully allowing the rope to unwind in
the starter housing assembly.
2. Place a 1" (25 mm) deep well socket under the
retainer. Set the rewind on a bench, supported on
the socket.
3. Use a 5/16" (7.938 mm) or 1/4" (6.35 mm) (for
stamped steel) roll pin punch to drive out the center
pin. The stamped steel center pin is driven out from
the top, inside the center hole. Move the punch around
while driving the pin to help keep the pin straight.
36
(DIAGRAM 4)
ONE PIECE ROPE RETAINER
HANDLE
ROPE
PULLEY AND REWIND
SPRING ASSY.
STARTER DOG
LEFT-HAND
KNOT
3
4
STARTER HOUSING
DOG SPRING
WASHER
RETAINER
BRAKE SPRING
WASHER
SPRING PIN
5
6