Chapter 3 Carburetors And Fuel Systems; General Information - Tecumseh ECV105 Technician's Handbook

CHAPTER 3 CARBURETORS AND FUEL SYSTEMS

GENERAL INFORMATION

Tecumseh uses two basic types of carburetors, float and diaphragm type carburetors. Float type carburetors use a
hollow float to maintain the operating level of fuel in the carburetor. Diaphragm type carburetors use a rubber-like diaphragm.
One side is exposed to intake manifold pressure and the other side to atmospheric pressure. The diaphragm provides the
same basic function (maintaining the proper fuel level in the carburetor) as the float.
An advantage of the diaphragm carburetor over the float style is that the diaphragm carburetor will allow the engine to
operate at a greater degree of tiltability.
Tecumseh carburetors are identified by a manufacturing number and date code stamped on the carburetor as illustrated
(diag. 1).
When servicing carburetors, use the engine model and
specification number to obtain the correct carburetor part
number. An alternate method of finding the correct
carburetor part number is to use the manufacturing number
stamped on the carburetor and convert this number to a
part number. In the carburetor section of the Master Parts
Manual, Microfiche Catalog or computer parts look-up
system, a cross reference chart will convert a carburetor
manufacturing number to a Tecumseh part number.
Complete carburetor replacement may be accomplished
with a standard service carburetor. A standard service
carburetor is a basic carburetor that may require the use
of original carburetor parts or additional new parts to adapt
to the specification. An instruction sheet is provided with
the new service carburetor or see "SERVICE" in this chapter.
CAUTION: DRAIN THE FUEL INTO AN APPROVED CONTAINER OUTDOORS, AND AWAY FROM ANY OPEN
FLAME OR COMBUSTION SOURCE. BE SURE THE ENGINE IS COOL.
NOTE: Todays fuels can cause many problems in an engines performance, due to the fuels quality and short shelf life.
Always check fuel as a primary cause of engine performance.
1. Remove the air filter, heater box, or air cleaner assembly if applicable to visually check that the choke shutter
completely closes or check to see if fuel comes out of the main nozzle during priming.
2. If the fuel flow from the tank is adequate and no fuel is evident during priming, the carburetor will need to be
removed for service. See "Service" in this chapter or consult the "Carburetion Troubleshooting" chart to diagnose
carburetor symptoms. Improper fuel flow indicates the fuel, fuel line, filter or tank require cleaning or replacement.
3. Check the engine compression using a commercially available compression tester and follow the tester's
recommended procedure. Low compression, a dry spark plug, adequate fuel flow, and a known good functional
carburetor indicates an internal engine problem exists. See under "Troubleshooting."
4. A wet spark plug indicates fuel is being supplied by the carburetor. The engine may be flooded by a restricted
air filter, carbon shorted or defective spark plug, excessive choking or over priming, improperly adjusted or
defective carburetor. With the spark plug removed and a shop towel over the spark plug hole, turn the engine
over slowly 3 or 4 times to remove excess gasoline from the engine cylinder.
CAUTION: KEEP ALL COMBUSTIVE SOURCES AWAY. AVOID THE SPRAY FROM THE SPARK PLUG
HOLE WHEN CRANKING THE ENGINE OVER.
5. Replace the air filter if restricted or oil soaked. Replace the spark plug if questionable. Install the spark plug and
high tension lead and try to start the engine.
6. If the engine floods and fails to start, the carburetor will require service. See the proceeding "Carburetion
Troubleshooting" chart for additional causes. If the carburetor is functioning properly the problem may be ignition
timing related. See "Troubleshooting" under "Ignition".
ALTERNATE LOCATION
FOR MANUFACTURING
NUMBER
MANUFACTURING
NUMBER
CARBURETOR
DATE CODE
1
7