Panasonic th-49lf8w Operating Instructions Manual page 9

Cleaning and maintenance
The front of the display panel has been specially
treated. Wipe the surface of the display panel gently
using only a cleaning cloth or a soft, lint-free cloth.
If the surface is par icularly dirty, wipe with a soft,
•
lint-free cloth which has been soaked in pure water or
water in which neutral detergent has been diluted 100
times, and then wipe it evenly with a dry cloth of the
same type until the surface is dry.
Do not scratch or hit the surface of the panel with
•
fingernails or other hard objects, otherwise the
surface may become damaged. Fur hermore, avoid
contact with volatile substances such as insect
sprays, solvents and thinner, otherwise the quality of
the surface may be adversely affected.
If the cabinet becomes dirty, wipe it with a soft, dry
cloth.
If the cabinet is particularly dirty, soak the cloth in
•
water to which a small amount of neutral detergent
has been added and then wring the cloth dry. Use this
cloth to wipe the cabinet, and then wipe it dry with a
dry cloth.
Do not allow any detergent to come into direct contact
•
with the surface of the Display. If water droplets get
inside the unit, operating problems may result.
Avoid contact with volatile substances such as insect
•
sprays, solvents and thinner, otherwise the quality of
the cabinet surface may be adversely affected or the
coating may peel off. Furthermore, do not leave it for
long periods in contact with articles made from rubber
or PVC.
Usage of a chemical cloth
Do not use a chemical cloth for the panel surface.
•
Follow the instructions for the chemical clo h to use it
•
for the cabinet.
Wired LAN
When setting up the Display at a place, where
electric statistic occurs often, take a sufficient anti-
static measure before start using.
When the Display is used at a location, where
•
static electricity occurs often, such as on a carpet,
communications of the wired LAN or DIGITAL LINK
are disconnected more often. In that case, remove
static electricity and the noise source that may cause
problems with an antistatic mat, and re-connect the
wired LAN or DIGITAL LINK.
In rare cases, the LAN connection is disabled due
•
to static electricity or noise. In hat case, turn off the
power of the Display and the connected devices once
and then re-turn on the power.
The Display may not work properly due to strong
radio wave from the broadcast station or the radio.
If there is any facility or equipment, which outputs
•
strong radio wave, near the installation location, set
up he Display at a loca ion sufficiently far from the
source of he radio wave. Or, wrap the LAN cable
connected to the DIGITAL LINK / LAN terminal by
using a piece of metal foil or a metal pipe, of which is
grounded at both ends.
Disposal
When disposing the product, ask your local
authority or dealer about the correct methods of
disposal.
9
English