Panasonic th-49lf8w Operating Instructions Manual page 53

■
[Network status]
Checks the current Network settings status.
Network status
DHCP
IP address
192. 168. 0. 8
Subnet mask
255. 255. 255. 0
Gateway 192. 168. 0. 1
MAC address
12:34:56:78:9A:BC
■
[DIGITAL LINK mode] (LF80 series only)
Switches communication method of DIGITAL LINK
terminal.
[Auto]:
Communication method is selected automatically.
[DIGITAL LINK]:
Communication method is fixed to DIGITAL LINK.
[Ethernet]:
Communication method is fixed to Ethernet.
[Long reach]:
Communication method is fixed to Long reach.
Modes allowing communication
: Valid
― : Invalid
Settings
transmission Ethernet
100 m 150 m
For
DIGITAL
LINK
Auto For Long
reach
For
Ethernet
DIGITAL LINK
Long reach
Ethernet
Note
●
When connected with the [Long reach]
communication method, the maximum
transmission distance is 150 m. In this case, this
unit can receive the signals of up to 1080/60p
(148 5 MHz).
● If the communication method of the twisted
pair cable transmitter is set to [Long reach], set
[DIGITAL LINK mode] to [Auto]. Then, connection
is enabled with the [Long reach] communication
method.
When connecting with the separately sold DIGITAL
LINK Switcher (ET-YFB200G) with the [Long
reach] communication method, set [DIGITAL LINK
mode] to [Long reach].
Off
Communication validity
Picture
232C
―
―
― ―
―
―
― ―
●
Even if [DIGITAL LINK mode] is set to [Long
reach], when the twisted pair cable transmitter
does not support the communication method of
[Long reach], it will not be connected properly.
■
DIGITAL LINK status (LF80 series only)
Display the DIGITAL LINK connection environment.
Select [DIGITAL LINK status] with
<ENTER>.
DIGITAL LINK status
LINK status
HDMI status
Signal quality
Min
Max
[LINK status]:
1 of the followings will be displayed.
[No link]:
No LAN connection, etc.
[DIGITAL LINK]:
Connected to the DIGITAL LINK device by LAN.
[Long reach]:
Communication method is set to [Long reach] and is
connected to the DIGITAL LINK device by LAN.
[Ethernet]:
The PC is connected to the DIGITAL LINK / LAN
terminal of this product and is LAN connected.
RS-
[HDMI status]:
1 of the followings will be displayed.
[No HDMI]:
DIGITAL LINK not connected
[HDMI ON]:
DIGITAL LINK connected
―
[HDCP ON]:
HDCP supported on DIGITAL LINK
―
and press
No link
No HDMI
-XX dB
-YY dB
English
53