ACOUSTIC SOLUTIONS CDAB-1 Instruction Manual page 11

USING THE DAB TUNER
STATION LISTS
Following the initial autotune upon power up, the CDAB-1 will build a station
list of services that exist in your area.
The default way in which these stations will be displayed on the LCD panel
is in alphanumeric order, recognising numbers before letters, therefore
stations such as 6 Music from the BBC will be listed first.
To change which station you are listening to, simply turn the rotary rotary
control knob clockwise to scan up through the alphabetical stations list, or
anticlockwise to scan down.
As you scroll up or down through the DAB stations stored in the memory
of the tuner, the LCD will display the name of the program on Line 1 of the
LCD, with the name of the multiplex displayed on line 2 of the LCD display.
To select a new station from the scrolling list, push the rotary control knob to
make your selection. (Note it is only necessary to press this button once to
make your selection). The DAB station will change to your new selection.
NOTE: you are able to activate an auto enter feature. This will allow the
DAB tuner to retune the DAB station automatically when you stop scrolling
through the stations without having to press the rotary control knob to
confirm your selection. This feature can be convenient, to activate press and
hold in the rotary control knob. The LCD display will read 'Auto enter ON',
this will now activate this feature. To turn this feature off, again press and
hold the rotary control knob, the LCD will display 'Auto enter OFF'.
Once the CDAB-1 has built a station list, it will retain this list in memory
unless you decide to reset it. Sometimes it may be the case that a particular
DAB station is not available in your area, however the station still exists
in the memory of the CDAB-1. This may occur if the DAB tuner has been
moved, and is now being operated in a different location. It may also be
that secondary level DAB stations (as described on page 2 ) are not being
broadcast, thus leaving this channel inoperative.
If you decide to select this station, the display will read 'Station not available'
and will revert back to the previous service.
SYSTEM RESET
In order to clear the station list from the memory of the unit you will need to
run a system reset and activate a quick scan.
Press and hold the info button to access a secondary menu.
Press the info button again to scroll through 2nd level option.
To select a system reset, press the rotary control knob to activate this
procedure. The CDAB-1 will commence a quick scan after the factory reset to
re establish the station list.
Page 10