Table of Contents
Advertisement
HANDLE
RECEPTACLE
DECK
ASSEMBLY
The machine is shipped with handle unassembled.
Follow these steps for installation:
1. Remove handle and deck assembly from carton.
2. Attach handle assembly to base using hardware kit (attached to handle in a plastic bag) items 1, 2, and 3.
NOTE: The spacers (items 1) are required for the correct operation of the handle. The spacers are positioned
completely inside the pivot holes in the casting, and are held in place by tightening the bolts and washers
(items 2 and 3) against the spacer.
3. Remove bolt, nut and washers (items 4, 5 and 6) from lower block on handle assembly. Attach links as
shown. Tighten bolt and nut securely, then back off 1/4 to 1/2 turn.
4. Check handle for movement up and down.
5. Plug motor cord into handle cord receptacle.
4
5
SPT1500 86037290 12/29/06
HANDLE INSTALLATION
HANDLE
ASSEMBLY
MOTOR
PLUG
6
1
SEE NOTE
PIVOT
HOLE
3
2
3-2
Advertisement
Table of Contents
