Learning Methods - Shimano DendoUmaru 1000 Plays Instruction Manual

Learning Methods

Spooling Up the Line
1 Feed the line through the level winder.
When threading the line, use the threading pin provided.
2 Tie the line to the spool pin.
Threading Pin
Spool Pin
16
(Entering the actual line length into the reel.)
Selecting Learning Methods
Firstly, change from standard mode to learning mode as shown
below. Be sure to select the learning method that best matches
the type of line you will be using.
Please refer to the following page for details regarding each learning
method.
* This operation cannot be carried out unless a power supply is
connected.
* Carry out this operation when the display shows less than 6m.
Please reset the counter if the value displayed is greater than 6.1m.
Caution:
If Learning is carried out when
off. If it does, please start Learning again from the beginning.
is displayed then the display may go