Product Description; Installation - Frigidaire FRSB205MJT Instruction Manual

Product description

3 4 5
1
2
Parts description
1
Freezer door shelves
Freezer compartment drawers
2
Freezer
3
Ice-maker drawer
4
Ice drawer
5
Compartment of door
6
refrigerator
Attention
Since we are constantly working to improve our products, your refrigerator may be
slightly different from the description contained in this manual, however, the functions
and operation of the procedure remain the same.
25
6
7
8
9
10
11
Refrigerator glass shelves
7
Refrigerator small drawer
8
Refrigerator door shelves
9
Refrigerator drawers for fruits
10
and vegetables
Lower cover
11

Installation

New refrigerator coming
Remove all packing, including bottom and inner foam and adhesive tape before
starting to use it.
Cleaning the inside and outside of it by a wet cloth (a little abstergent can be added
into the warm water, using clean water last).
A sole 2-pole receptacle with grounding contact is needful; do not share one
electrical outlet with other appliance.
Earthling line is essential, electrical outlet should be with a intact earthling line.
Transportation
Please don't inverted, squeezed, vibration refrigerator. When moving, the tilt angle
can't larger than 45 degree.
When moving, don't cling the door or coping.
Location
Ensure proper air circulation around refrigerator, don't place the unit near heat
source, direct sunlight, moisture or water, and avoid rust and weakening the
insulation.
Top space at least 30cm, space on both the sides and back at least 10cm from the
wall, So refrigerator' door can open or close convenience and emanate heat.
Installing the refrigerator on solid level floor(If don't level, it can adjust the leveler to
level).
Start using
Before it's started, make sure that the
refrigerator is installed on the solid and
level floor. .To understands all the
attention to security matters.
1. After unpacking the refrigerator,
please proceed to the more detail
figure in order to add the cover on
the refrigerator.
Attention
The decorative cover for the bottom beam is used as a ornament, so if you do not wish
to install it, it won't affect the refrigerators performance or conditions.
Decorative cover
Screws
for the bottom beam
26