Nokia 7610 User Manual page 72

72 Copyright © 2004 Nokia. All rights reserved.
The factory setting for the lock code is 12345. To avoid unauthorised use of your phone,
change the lock code. Keep the new code secret and in a safe place separate from your
phone.
• PUK and PUK2 codes (8 digits) - The PUK (Personal Unblocking Key) code is required
to change a blocked PIN code. The PUK2 code is required to change a blocked PIN2 code.
If the codes are not supplied with the SIM card, contact the operator whose SIM card
is in your phone for the codes.
You can change the following codes: lock code, PIN code, and PIN2 code. These codes can
only include the numbers from 0 to 9.
Avoid using access codes similar to emergency numbers, such as 112, to prevent accidental
dialling of the emergency number.
PIN code request - When the PIN code request is active, the code is requested each time the
phone is switched on. Note that deactivating the PIN code request may not be allowed by
some SIM cards.
PIN code / PIN2 code / Lock code
Autolock period - You can set an autolock period, a time-out after which the phone is
automatically locked and can be used only if the correct lock code is entered. Key in a
number for the time-out in minutes or select
• To unlock the phone, key in the lock code.
When the device is locked, calls still may be possible to the official emergency number
programmed into your device.
Lock if SIM changed - Select Yes
unknown, new SIM card is inserted into your phone. The phone maintains a list of SIM
cards that are recognised as the owner's cards.
- Open this setting if you want to change the code.
None to turn off the autolock period.
if you want the phone to prompt for the lock code when an