Scanning Fault Messages; Scanning Information; Scanning Information In The Standard Menu - Viessmann VITOLIGNO 300-C Operating Instructions Manual

Scanning

Scanning fault messages

If any faults have occurred in your heating system, the
symbol " " flashes in the display and "Fault" is
shown.
The heating contractor uses fault messages to quickly
pinpoint the cause of your boiler's fault. This can
reduce the time required to resolve the fault and there-
fore also your costs.
Make a note of the fault message displayed so you
can advise your heating contractor accordingly. This
makes preparations easier and may save extra travel
expenses.
Danger
Danger due to unresolved faults in the heating
system.
■ If a fault occurs, shut the system down and
make it safe.
■ Contact your heating contractor immediately.
Rectify the fault immediately or have a heating
■
contractor rectify it if necessary.
When rectifying the fault, no-one else should
■
be present in the danger zone around the
heating system.
1. You can call up the cause of the fault with
Fault
Outside temp sensor
Fault O2 probe
Acknowledge with
Fig.40
2. Pressing ? calls up information on the heating sys-
tem characteristics.
Tips on which measures you can take yourself
before notifying your heating contractor are also
displayed.
Calling up an acknowledged fault message in the standard menu
1. / for "Fault"
| ~

Scanning information

You can scan information in the standard menu and in
the extended menu. They differ in the extent of the
information displayed.

Scanning information in the standard menu

Note
Subject to system version, different information will be
available.
38
d .
34
91
OK
3. Make a note of the cause of the fault and the fault
code next to it on the right. In this example: "Out-
side temp sensor 34" and "Fault O2 probe 91".
This enables the heating contractor to be better pre-
pared for the service call and may save additional
travelling costs.
4. If you want to acknowledge the fault message, fol-
low the instructions in the menu.
The fault message is adopted into the menu.
Boiler water temp
Fault
Boiler
Buffer
Heating
Continue with
Fig.41
Note
■ If you have connected alarm equipment to indicate
fault messages (e.g. a buzzer), this alarm equip-
ment is deactivated when the fault message is
acknowledged.
If the fault can only be rectified at a later date, the
■
fault message is displayed again the next day and
the alarm equipment is switched on again.
2. to confirm.
d
If you select the "Heating" sub-menu, you can request
information on the required heating circuit via "
48°C
OK
/
Ù Ú
".