Wet Nozzle - RIDGID WD20620 Owner's Manual

Wet Nozzle

To pick up liquids off a smooth surface,
use the 2-1/2" wet nozzle accessory sup-
plied with your wet/dry vac. To use, simply
attach the nozzle to the end of an exten-
sion wand.
Connect a second extension wand to the
first, and connect the 2-1/2" x 7' hose to
the extension wand.
Liquids may be picked up by dragging the
nozzle across the surface. The squeegee
will dry the surface as you vacuum.
If the rubber becomes worn, it may be
flipped over for use on the opposite side
or replaced. (Replacement service part
#822256). To reverse or replace the
squeegee:
1. Lay the wet nozzle on a flat surface with
the round inlet opening facing up and
the two latches close to you as shown.
Latches
Removable
2. Using both hands, position each thumb
on the removable insert, (below the
latches) and two fingers of each hand on
each latch, lift and disengage the two
latches from the tabs on the nozzle body.
3. Gently pull the latches toward yourself
to remove the insert.
To reinstall the removable insert correctly,
follow these steps:
1. Place the removable insert on a flat sur-
face with the pins positioned upward
and the latches close to you as shown.
Place the rubber squeegee on the
insert, with the pins fitting through the
matching holes in the squeegee. (Make
sure the new working edge is located
Nozzle
Body
Insert
farthest from you.)
2. Using both hands, lower the nozzle
body onto the insert and squeegee with
the round opening of the nozzle closest
to you. With fingers on the far side and
thumbs holding the latches of the
removable insert, flip the nozzle over so
the latches are on the top and the round
inlet opening is facing away from you.
Make sure the squeegee stays on the
insert pins.
3. Press down with each thumb below the
latching tabs until you see and hear the
removable insert snap into the nozzle
body. Snap the latches over the locking
tabs into their original position.
4. Inspect the pins of the insert to make
sure they fit through the holes of the
squeegee and fit into the matching slots
in the nozzle body.
NOTE: If the pins are out position, hold the
nozzle assembly with both hands and gen-
tly twist in opposite directions. The insert
pins should snap into proper position.
Twist
Backward
The wet nozzle assembly is ready for wet
pickup use.
10
Twist
Forward