Advertisement
TO ASSEMBLE OR REMOVE BLADE
MODEL 315.1084100
See Figures 5, 6, and 7.
Unplug your saw.
WARNING:
Failure to unplug your saw could
result in accidental starting causing possible
serious personal injury.
SPINDLE LOCK BUTTON - MODEL 315.108410
If your saw is model 315.108410 it has a spindle lock
button for locking the spindle on your saw in a stationary
position. Depress and hold the spindle lock button while
installing, changing or removing the blade.
TO ASSEMBLE BLADE:
Remove blade wrench from storage area.
See Figure 1.
Position your saw as shown in Figure 7, depress
spindle lock button, and remove blade screw.
Figure 5.
Note: Turn blade screw counterclockwise to remove.
Remove spring washer, and outer blade washer
See Figure 5.
("D" washer).
SPINDLE
INNER FLANGE
BUSHING
OUTER
WASHER
("D" WASHER)
Wipe a drop of oil onto inner flange bushing and
outer blade washer ("D" washer) where they
contact blade.
WARNING:
If inner flange bushing has been
removed, replace it before placing blade on
spindle. Failure to do so could cause an accident
since blade will not tighten properly.
Fit saw blade inside lower blade guard and onto
spindle. Note: The saw teeth point upward at the
front of saw as shown in Figure 5.
ASSEMBLY
See
LOWER BLADE
GUARD HANDLE
BLADE
SPRING
WASHER
BLADE
SCREW
Fig. 5
Replace "D" washer and spring washer.
Note: "Cupped" side of spring washer goes
against "D" washer.
OUTER BLADE WASHER ("D" WASHER)
CUPPED SIDE OF
SPRING WASHER
Depress spindle lock button, then replace blade
screw. Tighten blade screw securely.
Note: Turn blade screw clockwise to tighten.
Return blade wrench to storage area.
Note: Always place angled portion of blade
wrench up as shown in Figure 1.
REMEMBER: Never use a blade that is too thick to
allow the "D" washer to engage with the flat on
the spindle.
TO REMOVE BLADE:
Remove blade wrench from storage area.
See Figure 1.
Position your saw as shown in Figure 7, depress
spindle lock button, and remove blade screw.
Note: Turn blade screw counterclockwise to remove.
Remove spring washer and outer blade washer
See Figure 5.
("D" washer).
Note: Blade can be removed at this point.
DEPRESS TO
LOCK SPINLDE
TO
TIGHTEN
TO
LOOSEN
10
See Figure 6.
OUTSIDE OF
SPRING WASHER
SPINDLE LOCK
BUTTON
BLADE
SCREW
BLADE
WRENCH
Fig. 6
Fig. 7
- Quick Links:
- Maintenance
Hide quick links:
Advertisement
