Philips HX6711 Service Manual

Philips Domestic Appliance and Personal Care
Service Manual
PRODUCT INFORMATION
Easy-start
The Easy-start feature will gently increase power over the first
14 brushings.
The Easy-start feature is active if you hear 2 beeps immediately
after turning on your toothbrush.
Once you reach the optimal brushing power, after the 14
brushing, you will no longer hear the double beep at the
beginning of the brushing routine.
Easy-start can also be switched off. To deactivate or reactivate
the Easy-start feature, see directions for use.
Smartimer
Automatically sets the brushing time to 2 minutes.
After these 2 minutes the product switches off automatically.
If you wish to pause, or stop brushing during the 2- minute
cycle, press the on/off button. When you press the on/off button
again, the Smartimer will pick up where you left off.
Programmable brushing modes
The programmable brushing allow you to customize the
brushing action. There are three different brushing modes.
Clean mode is the standard mode for superior teeth cleaning.
Sensitive mode provides gentle, yet thorough cleaning for
sensitive gums and teeth.
Clean and Whtie mode 2 minutes of Clean mode with an
additional 30 seconds of White mode to focus on your visible
front teeth. The White mode begins with a change in brushing
sound and motion which is the signal to start brushing the upper
front teeth. After 15 seconds a beep and pause will alert the user
to move to the bottom front teeth for the final 15 seconds.
Published by Philips Consumer Lifestyle
2/09
th
Printed in the Netherlands © Copyright Reserved
Sonic toothbrush
HX6711, HX6730, HX6731,
HX6732, HX6780, HX6781,
HX6782
Quadpacer
The Quadpacer feature ensures that you brush all four sections
of your mouth evenly and thoroughly. You will hear a short
beep and notice a brief pause in brushing action. This is the
signal to move to the next section of your mouth. To deactivate
and to reactivate the Quadpacer feature, see directions for use.
Battery charger indicator
Indicates amount of charge left in battery.
Deluxe charge indicator
Solid green LED: 50-100%
Flashing green LED: 10-49%
Flashing yellow LED: less than 10%
Standard charger indicator
Solid green LED: 50-100%
Flashing green LED: less than 50%
If the battery charge of your Sonicare is low, you will hear 3
beeps at the end of the brushing cycle and the charge indicator
LED flashes yellow for 30 seconds.
When the handle is placed in the charger, the charge indicator
LEDs will display the above patterns indicating the level of
charge.
Reminder bristles
Reminder bristles are introduced to remind the consumer to
replace their BHs at the recommended replacement time.
The color of the reminder bristles wears out as you use the
brush head and starts fading from the tip downward. When the
reminder bristles have faded half way it is time to replace the
brush head.
Subject to modification