Wired Remote Control Unit (Optional Parts); Parts Name And Functions - Technibel CAFP 124 RCAFP 164 RCAFP 184 RCAFP 254 RCAFP 364 R Instruction Manual

01_Technibel-PACi_EN.fm Page 18 Thursday, December 9, 2004 11:36 AM
O: Remote control sensor
J: TIMER SET button
K: Time setting buttons
G: CHECK button
N: VENTILATION button
F: FILTER button
A: ON/OFF operation button
B: Operation lamp
C: MODE button
D: Temperature setting
buttons
E: FAN SPEED selector button
18
Wired Remote Control Unit
(Optional parts)

Parts Name and Functions

• This remote control unit can be used to operate up to eight indoor units.
Once the operation settings are made, the units can be operated by
simply pressing the ON/OFF operation button.
• In the DSAFP series, the flap position is not shown on the display.
L: SET button
M: CL button
This button is for turning the air conditioner on and off.
This lamp lights when the air conditioner is turned on.
This lamp blinks when an error occurs or a protective device is activated.
Use this button to select one of the following five operating modes.
(AUTO) : Used to automatically set cooling or heating operation. Only for single
heat pump type
(HEAT) : Used for normal heating operation. Only for heat pump type
(DRY) : Used for dehumidifying without changing the room temperature.
(COOL) : Used for normal cooling operation.
(FAN) : Used to run the fan only, without heating or cooling operation.
: Press this button to increase the temperature setting.
: Press this button to decrease the temperature setting.
(AUTO) : The air conditioner automatically decides the fan speeds.
(HI.) : High fan speed
(MED.) : Medium fan speed
(LO.) : Low fan speed
B: Operation lamp
A: ON/OFF operation button
E: FAN SPEED selector
button
C: MODE button
D: Temperature setting
buttons
H: UNIT button
I: FLAP button
(temperature range: 17 to 27°C)
(temperature range: 16 to 30°C)
(temperature range: 18 to 30°C)
(temperature range: 18 to 30°C)
OI-722-18-EG