AEG BP5003021 User Manual page 27

• Clean all accessories after each use
and let them dry. Use a soft cloth with
warm water and a cleaning agent.
• If you have nonstick accessories, do
not clean them using aggressive
agents, sharp-edged objects or a
dishwasher. It can cause damage to
the nonstick coating.
10.2 Removing the shelf
supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support
away from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the shelf supports in the opposite
sequence.
10.3 Pyrolysis
CAUTION!
Remove all accessories and
removable shelf supports.
Do not start the Pyrolysis if
you did not fully close the
oven door. In some models,
the display shows "C3"
when this error occurs.
WARNING!
The appliance becomes very
hot. There is a risk of burns.
CAUTION!
If there are other appliances
installed in the same
cabinet, do not use them at
the same time as the
Pyrolysis function. It can
cause damage to the
appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Oven functions".
4. When flashes, press
set the necessary procedure:
Option
P1
P2
After 2 seconds the procedure starts.
You can use the End function to delay
the start of the cleaning procedure.
During the Pyrolysis the oven lamp is off.
5. To change the default length of the
procedure (P1 or P2), press
, and then press
the length of the cleaning procedure.
6. When the oven is at its set
temperature, the door locks. The
ENGLISH 27
or to
Description
If the oven is
not very dirty.
Time of the
procedure: 1
h 30 min.
If you cannot
easily remove
the dirt. Time
of the proce-
dure: 2 h 30
min.
to set
or to set