Hill Descent Control (Hdc) - If Equipped - Jeep 2014 Compass Owner's Manual

372 STARTING AND OPERATING
WARNING! (Continued)
that wheel lift or rollover may occur. ERM cannot
prevent all wheel lift or roll overs, especially those
that involve leaving the roadway or striking objects
or other vehicles. The capabilities of an ERM-
equipped vehicle must never be exploited in a reck-
less or dangerous manner which could jeopardize the
user's safety or the safety of others.
Hill Descent Control (HDC) — If Equipped
This system maintains vehicle speed while descending
hills during off-road driving situations. HDC will auto-
matically apply the brakes to control downhill speed to
between 4 mph (7 km/h) and 6 mph (9 km/h) depending
on terrain. The system is activated by placing the vehicle
in "Off-Road" mode and placing the shift lever in LOW
or REVERSE. Refer to "Safe Off-Road Driving" in "Start-
ing and Operating" for further information.
When HDC is properly enabled, the "Hill
Decent Control Light" in the instrument cluster
will be illuminated.
HDC has the capability to sense terrain and will only
activate when the vehicle is descending a hill. It will not
activate on level ground. If desired, HDC can be fully
deactivated by putting the vehicle into ESC "Full Off"
mode. This is done by pressing and holding the "ESC
Off" button for five seconds. Refer to "Electronic Stability
Control (ESC)" in this section of the manual.
HDC operation can be overridden with brake application
to slow the vehicle down below the HDC control speed.
Conversely, if more speed is desired during HDC control,
the accelerator pedal will increase vehicle speed like