Bartscher IKTS 35 Instruction Manual page 32

1. Assemble the serving trolley.
Begin by fastening the frames to the
arches. First, manually attach the frames to
the arches by screwing in the screws,
washers and nuts included with the device.
2. Place the serving trolley on its side and screw in the
swivel castors to the arches.
3. Fasten the wheel buffers above the swivel castors.
4. Place the serving trolley upright and check that all
the swivel castors are touching the floor.
5. Turn the allen screws very tightly using the hex key. Use the flat wrench to assist you
in holding the nuts still.
6. The swivel castors can be adjusted as needed.
NOTE!
Remove the protective foil immediately after assembly!
7. Place the induction plate into the
recess located in the upper shelf.
Ensure the device is properly inserted.
- 32 -
Allen screw
8. Use the lower tray for holding
pots, pans, dishes etc.
9. Block the swivel castors using
the brakes.
Nut
Washer