Install The Batteries; Recharge The Batteries; Recharge The Batteries Using The Power Supply; Recharge The Batteries Through The Usb Cable - Philips POCKET MEMO LFH0955 User Manual

3.3

Install the batteries

The digital recorder can be operated with the
two rechargeable AAA batteries delivered with
the product. Standard (non-rechargeable) AAA
alkaline batteries may also be used.
The on/off switch of the digital recorder
1
must be in the
OFF
Open the battery compartment on the
2
back side of the digital recorder by sliding it
outwards then folding it up.
Insert the two AAA batteries. The correct
3
polarity is indicated on the inside of the
battery compartment cover.
1
Close the battery compartment by folding
4
it back and sliding the battery compartment
cover inside until it clicks.
D Note
Do not mix battery types! Use two rechargeable
batteries or two non-rechargeable alkaline
batteries.
8
position.
1 2
3.4

Recharge the batteries

The digital recorder can be operated with the
rechargeable Philips AAA batteries. To recharge
these batteries, use the
Docking Station or the
3.4.1 Recharge the batteries using the
Philips power supply
Connect the Philips power supply to the
1
main power supply.
Connect the digital recorder to the Philips
2
power supply.
2
D Note
It is okay to continue using the digital recorder
during recharge. The batteries will be recharged
while you work, and will continue recharging
even when the digital recorder is turned off.
3.4.2 Recharge the batteries through the
USB cable
When the digital recorder is connected to a
PC or notebook computer with the supplied
USB cable, the rechargeable batteries are
automatically recharged. If the USB port on the
computer is high powered, a complete recharge
cycle takes about 2.5 hours.
The digital recorder switches into
mode and works like a loudspeaker and
microphone for the connected PC. To continue
recording on the digital recorder during USB
charging, change the USB mode to
Philips power supply, the
USB cable.
PC Download
USB supply
User manual
by