Power Supply; Setup Recommendations; Inserting Batteries In The Remote Control - Philips CDR776/00C Instructions For Use Manual

INSTALLATION

Power supply

1 Plug the power cord supplied into the MAINS connector on
the CD recorder, then into a mains socket.
2 Press ON/OFF.
The recorder is now in Standby mode.
3 Press any key to activate the recorder.
Note:
- The CD recorder will automatically adjust to the local mains
voltage.
- When the CD recorder is in the 'OFF' position, it is still
consuming some power. If you wish to disconnect your
player completely from the mains, withdraw the plug from
the AC outlet.

Setup recommendations

- Place the CD recorder on a solid, vibration free surface.
- Do not place the CD recorder near a source of heat or in
direct sunlight.
- Do not use the CD recorder under extremely damp
conditions.
- If the CD recorder is placed in a cabinet, make sure that a
2.5 cm space remains free on all sides of the CD
recorder/player for proper ventilation.
14

Inserting batteries in the remote control

1 Open the battery compartment cover.
2 Insert 2 batteries ("AA", LR-6 or UM-3; as supplied) as
shown.
3 Replace the cover.
Note: We recommend you use 2 batteries of the same type
and condition.
Batteries contain chemical substances, so they should
be disposed of properly.