Rinse Aid Indicator; Setting The Rinse Aid Dosage - Miele G 6160 Operating Instructions Manual

Rinse aid indicator

When the Rinse Aid indicator lights up,
the rinse aid reservoir contains suffi‐
cient rinse aid for 2 - 3 programs only.
 Add rinse aid.
If you only ever use combination prod‐
ucts in your dishwasher, you can
switch both refill indicators for salt
and rinse aid off if you wish (see "Op‐
tions - Refill indicators").

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage is set in stages
from 0 to 6. It is set to 3 at the factory.
This is the recommended setting.
The dosage can turn out to be higher
than the set value due to the automatic
adjustment of the Automatic program.
If spots appear on dishware and glass‐
ware:
 Increase the rinse aid dosage.
If clouding or smearing appears on
dishware and glassware:
 Decrease the rinse aid dosage.
Before using for the first time
 Turn the dishwasher off with the 
button, if it is turned on.
 Press the program selection button
, and, simultaneously switch the
dishwasher on using the  button.
Keep the program selection button 
pressed in for at least four seconds
until the lower right program indicator
light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
 Press the  button 3 times.
The  indicator light will flash 3 times
at short intervals.
The set value will appear in the display
after .
The flashing sequence   will appear in
the display.
This indicates a factory default setting
of 3.
 Use the program selection button 
to select the setting required.
Each press of the button moves you
up a level.
The setting is now stored in memory.
 Turn the dishwasher off with the 
button.
25