NA-16VX1/16VG1/14VA1
Description
6 Replacement of
the PC Board for
operation
Figure
4.pull all pawls up to remove the detergent case A
from the body joint.
5.Remove the two screws mounting the feed valve
unit as shown in left figure.
6.Remove the three connectors from the feed valve
unit, and pull it out to remove by a screwdriver.
After remove the upper board,
1.Remove the detergent case B, and remove the
one screw mounting the panel face board.
2.Remove another screw mounting the panel face
board.
3.Insert the metallic ruler between the panel face
board and the body B to remove the two pawls.
4.Pull out the panel face board to remove.
Note:
Please roll the tape at tip of the tool to prevent
scratch on the surface of the panel face board.
-28-
Procedure