Day/Night Tab - Sony SNC-CH110 User Manual

Metal halide lamp: Sets the white balance to that
suitable for photography under a metal halide lamp.
White LED: Sets the white balance to that suitable for
photography under the light of white LEDs.
One push WB: The One push trigger button becomes
active. Click the button to adjust the white balance
instantly.
Manual: When this option is selected, R gain and B
gain become active. Selectable gain values are from
0 to 4095.
NR
Image noise can be reduced by using the NR function.
Select Off to disable the function.
Gamma setting
Set the gamma curve in the camera. Depending on
subject or recording conditions, the following settings
will be available:
Normal: This setting is suitable for many scenes.
Scene 1: This setting is suitable for shooting dark areas
without losing detail of bright areas when the subject
is in high contrast, such as both sunlight and shadow.
Scene 2: This setting is suitable for obtaining an effect
stronger than Scene 1.
Scene 3: This setting is suitable for shooting dark areas
brightly when the subject is in high contrast, such as
both sunlight and shadow.
Scene 4: This setting does not perform gamma
correction. It is suitable for picture processing of an
image you shot.
Scene 5: This setting is suitable for preventing bright
subjects from overexposure.
Scene 6: This setting is suitable for using a display
system with a gamma characteristic of 1.8.
Brightness
Select the brightness in 11 steps, from –5 to +5.
Selecting +5 provides the brightest picture.
Saturation
Select the saturation in 7 steps, from –3 to +3. Selecting
+3 provides the highest image saturation.
Sharpness
Select the sharpness in 7 steps, from –3 to +3. Selecting
+3 provides the sharpest picture.
Contrast
Select the contrast in 7 steps, from –3 to +3. Selecting +3
provides the highest contrast.
OK/Cancel
See "Buttons common to every menu" on page 23.

Day/Night Tab

Use this tab to set the easy day/night function of the
camera.
Since this function enables noise reduction, dark
monitoring images from the camera can be switched
automatically to monochrome images (night mode).
Preview screen
This screen is for monitoring images and configuring
easy day/night settings.
For details on each button, refer to the Control bar of the
Plug-in free viewer (page 16).
Electrical D/N
Auto: Normally works in day mode; switches
automatically to night mode in a dark place.
Off: Always works in day mode.
Note
If AGC is set to Off, night mode will not be
automatically set, even when the day/night mode set to
Auto.
OK/Cancel
See "Buttons common to every menu" on page 23.
Setting the Camera Image — Camera Menu
31