Using The Trigger Button; Sending A Monitor Image Via E-Mail; Sending A Monitor Image To An Ftp Server; Switching Transmission Mode - Sony SNC-CH110 User Manual

Using the Trigger Button

You can execute various functions by clicking their
respective buttons on the Trigger panel.

Sending a monitor image via e-mail

You can send a captured still image by attaching it to an
e-mail.
To use this function, you need to make e-Mail (SMTP)
active and set the address in the Trigger menu of the
Administrator menu properly (page 63).
1
Click e-Mail (SMTP) on the Trigger panel.
The still image of the time you click is captured,
and your e-mail with the image file attached is sent
to the specified mail address.
Sending a monitor image to an FTP
server
You can send a captured still image to the FTP server.
To use this function, you need to make FTP active and
set the address in the Trigger menu of the Administrator
menu properly (page 64).
1
Click FTP client on the Trigger panel.
The still image of the time you click is captured,
and the image file is sent to the FTP server.
Switching Transmission
Mode
You can select the Transmission mode for video/audio
data.
This function can be used when Mode (video codec
mode) is set to MPEG4 or H.264 and the ActiveX
viewer is used.
Note
The function may not operate correctly if you use
personal firewall software or antivirus software on your
computer. In that case, disable the software or select the
TCP mode.
1
Select TCP, Unicast or Multicast from the
Connection drop-down list in the Others panel.
TCP: This is normally selected.
When TCP is selected, HTTP communication is
adopted for video communications.
HTTP is the protocol used for reading the usual
Web page.
In an environment capable of reading Web pages,
you can watch video by selecting the TCP port.
Unicast: When Unicast is selected, RTP (Real-
time Transport Protocol) is adopted for video
communications. Since RTP is the protocol for
running video data, the video playback is smoother
than when TCP (HTTP) is selected. If a firewall is
installed between the camera and the computer, or
depending on the network environment, video may
not play back properly when Unicast is selected. In
this case, select TCP.
Multicast: This protocol is selectable when
Multicast streaming (page 35) is On. When
Multicast is selected, RTP (Real-time Transport
Protocol) and UDP multicast techniques are
adopted for video transmission. By selecting it, the
network transmission load of the camera can be
reduced. If a router that does not correspond to a
multicast or firewall is installed between the camera
and the computer, video may not play back
properly. In this case, select TCP or Unicast.
Note
When you are connected to a Proxy server, Unicast
or Multicast cannot be selected.
Using the Trigger Button / Switching Transmission Mode
19