Ford Expedition 2006 Owner's Manual page 575

Hide thumbs Also See for Expedition 2006:

Table of Contents

Available languages

Before following the procedure, make sure that:

• The parking brake is set

• The gearshift is in P (Park) (automatic transmission)

• The ignition switch is in the OFF position

• The driver safety belt is unbuckled

To reduce the risk of injury, do not deactivate/activate the

feature while driving the vehicle.

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT

START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1

• Step 3 must be completed within 50 seconds after the safety belt

warning light turns off.

3. At a moderate speed, buckle then unbuckle the safety belt 9 times,

ending in the unbuckled state. (Step 3 must be completed within 50

seconds after the safety belt warning light turns off.)

• After Step 3, the restraint system warning light (airbag light) will be

turned on for three seconds.

4. Within 10 seconds of the light turning on, at a moderate speed, buckle

then unbuckle the safety belt.

• This will disable the BeltMinder

is currently enabled. As confirmation, the restraint system warning

light will flash 4 times per second for 3 seconds.

• This will enable the BeltMinder

is currently disabled. As confirmation, the restraint system warning

light will flash 4 times per second for 3 seconds, followed by 3

seconds with the light off, then followed by the restraint system

warning light flashing 4 times per second for 3 seconds again.

2006 Expedition (exd)

Owners Guide (post-2002-fmt)

Seating and Safety Restraints

feature for that seating position if it

Show Quick Links

Table of Contents