Power Cable Connections And Switching The Power On/Off; Operating - Mitsubishi Electric XD60U User Manual

Power Cable Connections and Switching the Power On/Off

There is an order in which the power cable is connected and the power is switched on/off.

Operating

1
Connect the AC IN connector of the projector and the power outlet using the supplied power cable.
The STANDBY indicator will light in amber, and the unit will enter the standby mode.
2
Switch on the projector power
Main unit operation: Press the STANDBY button.
Remote control operation: Press the STANDBY button.
STANDBY
MENU
RGB ENTER
VIDEO CANCEL QUICK
Q
FREEZE MUTE LAMP MODE AUTO
1 2 3 4
ASPECT
The first time the power is switched on after purchase, [Menu Language Select] will be displayed. See Page E-22 for
information about language selection.
• When the power is switched on, the STANDBY indicator changes to blinking green, then lights steadily after about 60
seconds and the projection screen is set to the brightness of normal mode. At this time, if the STATUS indicator is lit in
green, [Lamp Mode] is set to "Low". See Pages E-28 and E-50 for information about the selection method.
• If the power does not come on, see "When the STATUS Indicator is Lit or Blinking" on Page E-55.
If the "Password" input window is displayed: See Page E-33.
A password is set for this projector.
The projector cannot be used unless the correct password is input.
To turn off the power: See Page E-23.
The projector is now capable of regular projection.
3
Switch on the power of the connected equipment
Note:
• When the power plug will be unplugged from the power outlet, please place the projector near the power outlet so that it may be reached
easily.
• Press the STANDBY button after the STANDBY indicator is lit in amber.
• The included power cable is exclusively for use with the XD60U. Never use it with other products.
• Use the appropriate cord for your country.
• The provided power cord for the U.S. is rated at 120 V. Never connect this cord to any outlet or power supply using other voltages or
frequencies than rated. If you want to use a power supply using other voltage than rated, prepare an appropriate power cord separately.
Lit amber
STATUS STANDBY
Firmly plug in all the way.
Lit amber
STATUS STANDBY
E-21
Blinking green
(Approximately 60 seconds)
STATUS STANDBY STATUS
This indicator is also lit green in Low-mode.
To wall outlet
Lit green
Power is on
STANDBY