Aiwa CDC-X927M Service Manual page 6

DISASSEMBLY INSTRUCTION - 1/2
Q Q
3 7 6 3 1 5 1 5 0
9) Remove MOTOR assy.
10) Remove FRONT assy.
11) Remove Panel SW assy.
(Extend FRAME SUB assy lightly and remove it at front side)
T E
L 1 3 9 4 2 2 9 6 5 1 3
12) Remove SHAFT assy.
(Remove the washer. See figure)
w w w
x a o
y
. i
http://www.xiaoyu163.com
8
Reassemble MOTOR assy at the position that is arranged with hole of GEAR CAM and hole of FRAME SUB assy like the figure)
Put the tip of a lever Assy gear at between the marks of GEAR CAM and reassemble FRONT assy.
(Extend FRAME SUB assy lightly.)
Q Q
3 7 6 3
Put GEAR CAM at the position that hole of FRAME SUB assy can be seen from the left and right side hole of GEAR CAM, and reassemble SHAFT assy.
u 1 6 3
.
-6-
http://www.xiaoyu163.com
9 2 4 9 8
1 5 1 5 0 8 9 2 4
m
c o
2 9 9
9 8 2 9 9