Lennox NV35IN Care And Operation Instructions Manual page 13

LENNOX HEARTH PRODUCTS • SIGNATURE
Installing and removing the glass door
WARNING
• Do not attempt to substitute
the materials used on these
doors, or replace cracked or
broken glass.
• Handle this glass with
extreme care! Glass is
susceptible to damage—Do
not scratch or handle roughly
while reinstalling the glass
door frame.
• The glass door of this appliance
must only be replaced as a
complete unit as provided
by the manufacturer. Do not
attempt to replace broken,
cracked or chipped glass
separately.
• Do not attempt to touch the
front enclosure glass with your
hands while the fireplace is
in use.
WARNING
Do not operate appliance with
the glass front removed, cracked,
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si
le panneau frontal en verre
n'est pas en place, est craqué,
ou brisé.
Only doors certified with the appliance shall
be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
CAUTION
DO NOT abuse glass door by
striking or slamming shut.
NOTE: When installing the glass door,
ensure the spacing on both sides is even.
SERIES DIRECT-VENT GAS FIREPLACES • ENVY/ENVY CD 35/40/45 • CARE AND OPERATIONS
®
Installing the glass door
1. Retrieve the glass door. Visually inspect
the gasket on the backside.
NOTE: The gasket surface must be
clean, free of irregularities, and seated
firmly. Ensure it is properly located.
Make sure the bead is not rolled into
the channel at the top of the door, but
remains flat against the top of the glass.
2. Locate the four (4) spring-loaded
latches; two above and two below the
fireplace opening (Figure 13).
Figure 13: Glass Door
Latch
3. Carefully grip the door at the top and
bottom, and align it with the fireplace
opening. Lightly press against the door,
to hold it in position.
4. Secure the two upper latches by pulling
each handle down and pressing in to
hook it to the glass door.
5. Secure the two lower latches.
DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Installing the Surround Trim Assembly
1. Identify the left and right side finish trim
gap fillers (Figure 14).
Figure 14: Finish Trim Gap Fillers
Left
Latch
2. Install the surround trim assembly
by lowering it onto the appliance and
pressing in to secure it (Figure 15).
Figure 15: Installing the Surround
Trim Assembly
Latch
Side Tabs
3. Slide the left finish trim gap filler
into the left gap between the finish
SCALE 0.200
trim and the surround trim assembly
(Figure 16).
NOTE: Ensure the finish trim gap filler
slides into the spring clip, as shown.
Figure 16: Finished Installation
Spring Clip
4. Slide the right finish trim gap filler
into the right gap between the finish
trim and the surround trim assembly
(Figure 16).
NOTE: Ensure the finish trim gap filler
slides into the spring clip, as shown.
Right
13