Viewing Computer Images - Mitsubishi Electric XD1000 User Manual

Viewing computer images

A. Connecting the projector to a computer
Preparation:
• Make sure that the power of the projector and that of the computer are turned off.
• When connecting the projector to a desktop computer, disconnect the RGB cable that is connected to the monitor.
COMPUTER IN/COMPONENT
VIDEO IN-1
1
2
COMPUTER IN/COMPONENT
VIDEO IN-2
1
2
DVI-D (HDCP)
1
2
1
AUDIO IN
PC audio cable (option)
• Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending
on the type of the computer to be connected.
• Use of a long cable may decrease the quality of projected images.
• Images may not be projected correctly, depending on the type of the connected computer.
• When DVI-D signal is input, some signal setting menus are unavailable.
• Also read the instruction manual of the equipment to be connected.
• Contact your dealer for details of connection.
For analog connection:
(For using the COMPUTER/COMPONENT VIDEO IN-1
terminal.)
1. Connect one end of the supplied RGB cable to the
to monitor port
2. Connect the other end of the RGB cable to the monitor
RGB cable
• When viewing images supplied from an analog-connected
For analog connection:
(For using the COMPUTER/COMPONENT VIDEO IN-2
terminal.)
1. Connect one end of a commercially BNC cable to the
to monitor port
(5 BNC)
2. Connect the other end of the BNC cable to the 5 BNC
For digital connection:
1. Connect one end of a commercially available DVI cable to
2. Connect the other end of the DVI cable to the DVI terminal
• When viewing images supplied from a digital-connected
to DVI
• Turn on the main power switch of the projector before
DVI cable
For audio connection:
1. Connect one end of a commercially available PC audio
Computer
2. Connect the other end of the PC audio cable to the audio
• This projector uses stereo pin jack for its audio input. Check
AUDIO OUT • Speaker output is mono.
to audio output
2
terminal
COMPUTER IN/COMPONENT VIDEO IN-1 terminal of the
projector.
port of the computer.
computer, press the COMPUTER button on the remote
control.
COMPUTER IN/COMPONENT VIDEO IN-2 terminal of the
projector.
terminals of the monitor port of the computer.
the DVI-D (HDCP) terminal of the projector.
of the computer.
computer, press the DVI-D(HDCP) button on the remote
control.
starting the computer.
cable to the AUDIO IN-1/2 terminal of the projector.
output terminal of the computer.
the type of the audio output terminal of the connected
computer and prepare a proper cable for connection. Some
computers don't have the audio output terminal.
EN-13