Stopping The Engine - NorthStar M296026C Owner's Manual

Handle bar
Stop the engine using the following steps:
1. While holding cutting wheel off the
ground, release the operator presence bar.
The engine will stop. Wait until the cutter
wheel completely stops. Lower the cutter
wheel so it is resting against the ground.
2. Make sure brake is set before leaving the
controls, particularly if you are on an
incline.
3. Turn engine switch to OFF position.
4. Allow the engine to cool for at least 5
minutes before releasing brake and moving
to storage or transporting. A hot engine
can be a fire hazard.
Operation
Operator presence
bar

3. Stopping the Engine

Throttle lever
Brake lever
Operator presence
bar
13
Cutting wheel
Brake lever