Fill stump grinder
gasoline tank
Inspect Fuel
System / Check for
Leaks
Locking Handle
Bar
Operation
Check the gasoline level in the engine's fuel tank. If needed, fill tank with
fresh unleaded gasoline from a portable container, after first reading the
warnings and instructions below.
- Do NOT fill the gas tank to the top. Gasoline may spill when operating
on a slope.
- Do NOT overfill the gasoline tank. Allow at least 1" of empty space
below the fill neck to allow for fuel expansion.
WARNING: Gasoline fire/explosion hazard
Gasoline is highly flammable and explosive. Heat, sparks, and
flames can ignite gasoline vapors, which can become widespread
during fueling. A flash fire ignition and/or explosion could result
and cause serious injury or death. The following conditions could
result in gasoline ignition/explosion:
gas vapor collection inside enclosures
static electric sparks
sparks from electric wiring, batteries, or running engines
sources of heat (such as a hot engine or exhaust)
open flames, including pilot lights
Inspect fuel system & check for leaks BEFORE starting grinder.
WARNING: Fuel leak hazard
A leaking fuel line no matter how small can be the source of a fire or
explosion when starting or operating the engine.
Inspect the entire fuel system. Look for: Signs of leaks or deterioration,
chafed or spongy fuel hose, loose connections, loose or missing fuel
hose clamps, damaged gasoline tank, or defective gasoline shut-off
valve.
If grinder is in an enclosed area and you smell gas, DO NOT start
engine! DO NOT light a match. DO NOT flip on an electrical switch.
Exit area immediately leaving doors open and call fire department.
Handle is capable of folding when not in use.
To lock handle into place:
Position T-handle knob and eyebolt so it is on the back side of the
hinge bracket.
Tighten T-handle knob finger tight.
Repeat on other side
To fold handle:
Turn T-handle knob counterclockwise to loosen.
Swing knob and eyebolt to the outside, on both sides of handle.
Carefully fold handle downward until it comes in contact with the
rubber stops.
10