Table of Contents
Advertisement
After you have completed the pre-start checklist and procedures, you are ready to start the
grinder.
The following directions detail how to start the engine of your grinder.
WARNING:
Never attempt to use the grinder without proper protective equipment,
particularly eye protection and a full-face shield.
To start the grinder:
Note: For additional engine starting instructions see your Honda engine manual.
1) Lock handle in the upright position.
2) Place stump grinder into position with cutting wheel near the front-top edge of the stump.
3) Use brake lever on handle to lock the wheel brake.
WARNING:
Stay in the OPERATOR POSITION (behind the machine) while
actuating controls. Never leave grinder unattended.
4) For cold engine, move choke lever to the CLOSED position. To restart a warm engine, leave
choke lever in OPEN position.
5) Turn engine switch to the ON position.
6) Grip operator presence bar and handle bar together in left hand.
WARNING:
A rotating cutting wheel is very dangerous. Stay at the controls and keep
others away until you are sure the blade has come to a complete stop.
7) Pull the starter grip lightly until you feel resistance, then pull briskly. Return the starter grip
gently. If the choke lever was moved to the CLOSED position to start the engine, gradually
move it to the OPEN position as the engine warms up.
8) If engine does not start, repeat steps 5-7.
9) Press down on handle bar to lift cutter wheel off the ground.
10) Grip throttle lever and handle bar together in left hand. Centrifugal clutch will engage and
cutter wheel will begin to rotate.
Operation
2. Starting the Grinder
12
Advertisement
Table of Contents
