Disassembly Instruction - Samsung ML467 series Service Manual

DISASSEMBLY INSTRUCTIONS
1. Fig. A (CABINET)
Loosen two screws (A) holding Cover·Rear and Cover·
Front, and the screw (B) in order to release the Cover·
Rear from the Chassis·Frame, and the screw (C) in order
to release Cover· Rear from the Back-Holder, Cord.
Remove the Cover-Rear by pulling Cover-Rear backward
while pushing the inner latches in direction of (E), using
two jigs(D).
2. Fig. B (PWB's)
1) The CRT must be discharged firstly. Refer to the high
voltage discharge procedure for important safety precau·
tions.
2) Remove the CRT's anode cap(a) from the CRT.
3) Disconnect the ground lead and remove the PWB-CRT
~v
I
1
FIG 1
j;EfJJ
~ /lj~L
1
(MATERIAL STEEL PLATE)
9
from the Chassis-Frame.
4) Remove Chassis· Frame from the Cover-Front by loosen-
ing screws (b).
5) Loosen two screws (c) holding the Chassis-frame and
Back-Holder, Cord.
6) Loosen five screws (d) from the Chassis-Frame and
remove PWB·Main.
7) loosen two screws (e) from the Chassis-Frame and remove
PWB·Power.
8) Loosen four screws (f) to remove Trans·Power from the
Chassis·Frame.
9) Remove the lug·terminal from the Chassis· Frame by
unscrewing (g).
FIGURE B. PCBS
FIG 2