The float for this unit is foam filled to assist in buoyancy.
The pump casing is hard anodized aluminum.
The impeller is manufactured from bronze. It is ground and dynamically
balanced for maximum performance.
The suction head is anodized aluminum.
The engine is a gasoline powered, Briggs and Stratton, vertical shaft
model.
The engine has a built in governor to limit the engine speed.
The fuel tank is plastic.
The fuel tank capacity is 2.8 quarts and should allow for an approximate
run time of 47 minutes at full load.
The throttle has an integrated on/off design, off is full slow.
The engine choke is built into the throttle.
Prepared by: RJG
Approved by: TED
Revised by: TED
Rev. A
Date: 03/04/10
Rev. Date: 30June2015
1200627.doc