Adjusting The Midi Map - NFUZD Audio NSPIRE series User Manual

Quick Nav
Table of Contents
Introduction
I/O Module Panel Layouts
Snare and Tom Trigger Zones
NFUZD USB Key (Drive) and Data Management
NSPIRE Series I/O Module Navigation
Trigger Settings
Hi-Hat (HH) Trigger Settings
Kit Menu
Reverb
EQ
Mixer Menu
Saving a UserKit

Adjusting the MIDI Map

Trigger Function Settings
Click Menu
SEQ Menu
Integration with Computer
Setup Suggestions
Sync Key
Auto Off and Sleep Mode
BFD Eco NFUZD Edition
NSPIRE Series I/O Module Settings
Getting Started w/ BFD Eco NFUZD Edition
Basic Mixing Adjustments
BFD Eco NFUZD Edition Effects
Grooves Page
Options Menu
Help Menu
Changing BFD Eco NFUZD Edition Presets
Changing Drum Sounds
Adjusting Instrument Parameters
FX Slots
Instrument and Mixer Faders
Getting New Professional Sounds
User .wav Samples
Exporting Sound Banks
Loops
Installing Sound Banks
BFD Eco Jukebox Player
BFD Eco Master Output Recording
BFD Eco Mixing Tips
Included Sounds
Adjusting the MIDI Map
The NSPIRE set ships with a few common note maps to work with a variety of Software programs. These maps are in the MIDI Maps folder
on the NFUZD Audio USB Key. Make sure you keep a copy of this data. The USB key is used to read and load the maps.
1. BFD
2. TD 20 (This map is also found in most software)
3. SD2
4. EZ Drummer
5. SSD
6. GM
7. Empty_07
8. Tom2Loop
9. Ballad
10. StackDr
* Note: Software Drum VSTi programs allow you to make a custom MIDI map within the program. These program maps listed above are
based on the default settings for the programs as listed in the user manuals for each. It is recommended to check them and make the
adjustments in the software. This will save you from creating note maps in the NSPIRE module and allow you to use that space for
creative mappings instead.
Press the TRIG button on the right of the module. Press the F3 (MIDI) key. (The HH has one more step. You must go to the F3 (ADV) page
first and then you will see the F3 MIDI function.)
The first parameter is the trigger Mode. You can choose to use Single (default), Stack, Loop, or Kit +/- (PERC channel only).
You must save the trigger modes to a MIDI map in order to link them to a User Kit.
Each trigger zone has the ability of choosing a different MIDI Channel and Note for outgoing MIDI information. The MIDI information is
independent of the internal voices. This is a really creative way to build User Kits that can involve outboard equipment by addressing
different MIDI locations in your entire system.
2 9