Eq - NFUZD Audio NSPIRE series User Manual

Quick Nav
Table of Contents
Introduction
I/O Module Panel Layouts
Snare and Tom Trigger Zones
NFUZD USB Key (Drive) and Data Management
NSPIRE Series I/O Module Navigation
Trigger Settings
Hi-Hat (HH) Trigger Settings
Kit Menu
Reverb

EQ

Mixer Menu
Saving a UserKit
Adjusting the MIDI Map
Trigger Function Settings
Click Menu
SEQ Menu
Integration with Computer
Setup Suggestions
Sync Key
Auto Off and Sleep Mode
BFD Eco NFUZD Edition
NSPIRE Series I/O Module Settings
Getting Started w/ BFD Eco NFUZD Edition
Basic Mixing Adjustments
BFD Eco NFUZD Edition Effects
Grooves Page
Options Menu
Help Menu
Changing BFD Eco NFUZD Edition Presets
Changing Drum Sounds
Adjusting Instrument Parameters
FX Slots
Instrument and Mixer Faders
Getting New Professional Sounds
User .wav Samples
Exporting Sound Banks
Loops
Installing Sound Banks
BFD Eco Jukebox Player
BFD Eco Master Output Recording
BFD Eco Mixing Tips
Included Sounds
EQ
The NSPIRE I/O module includes a four–band master EQ that can be dialed in and saved for each preset.
Start on the main KIT page and press F2 (EQ).
The EQ in the NSPIRE module is a four–band fixed–frequency system. The middle two frequencies allow you to further control the "Q", or
width of the adjustment. The high and low frequencies use a simple gain adjustment only.
Use F1 (up) and F2 (down) to navigate this page. F3 (BACK) takes you back to the main Kit page.
EQ Out
High Gain
High Mid Gain
High Mid Q
Low Mid Gain
Low Mid Q
Low Gain
Main Out and Direct 1 and Direct 2
+/- 12 dB at 15 kHz
+/- 12 dB at 8 kHz
0.5 – 1.0
+/- 12 dB at 328 Hz
0.5 – 1.0
+/- 12 dB at 80 Hz
2 5