Entrance Monitoring; Room-To-Room Communication - Aiphone JF-2MED Installation & Operation Manual

8-3 Message for entrance
1
During communication, instant voice call or entrance
monitoring, press MENU/MEMO button to display the
menu screen.
2
Press PLAY button.
PRESS THE TALK BUTTON TO END
8-4

Entrance monitoring

1
Press MONITOR button in the standby mode.
2
The video monitor displays the image from door
station 1 and the incoming audio is heard. If you
do not press TALK button, the caller will not hear
sounds from the inside station.
8-5

Room-to-room communication

1
Press CALL button to talk with the other person.
• CALL button (red) flashes and the "All Call" function is
activated to link all the master/sub stations.
• The reply of the other person is not heard.
2
If the other person presses TALK button, hands-free
communication is possible.
Do not press TALK button during communication.
It will end the commnication.
3
Press either CALL button or PLAY button. The selected Message changes
to yellow, "SENDING MESSAGE" is displayed, and the selected message
is played from door station.
PRE SS
THE TALK
BUTT ON
TO END
.
NOTES: Record separate messages in advance for Message 1 and
3
4
Press MONITOR button again to end.
NOTES: 1. To talk to the entrance during monitoring, momentarily press TALK button.
3
Press and release TALK button to end.
NOTES: 1. Room-to-room communication ends automatically after approx. 10 minutes.
SEND MESSAGE FOR ENTRANCE
Message 2. (Refer to section 7-6)
Press MONITOR button again to switch to door station 2. Each time MONITOR
button is pressed, the unit switches in the sequence "Standby" to "Door station 1
monitor" to "Door station 2 monitor" to "Standby".
When "Audio door station" or
is set in the door station 2 setting, "Door station 2 monitor" is skipped (door
station 2 cannot be monitored). (Refer to section 7-7)
Press TALK button again to end communication.
2. The entrance monitoring turns off automatically after approx. 1 minute. To
monitor the entrance again, repeat from the beginning.
To perform room-to-room communication again, repeat from the beginning.
2. If a call is received from the entrance during room-to-room communication,
a chime tone sounds from the monitor station and sub station where
communication is taking place. Press TALK button to end the room-to-room
communication, and press TALK button again to switch to communication
with door station from which the call was received.
- 11 -
SENDING MESSAGE
"Door station 2 not connected"