Safety Instructions - Kärcher SC 1502 Instruction Manual

2. Safety Instructions

The warning and information decals attached to
the unit feature provide important details for safe
operation.
In addition to the information provided in the
Operating Instructions, the general safety
regulations and accident prevention ordinances
imposed by official authorities must be
observed.
Electrical Connection
Connect the unit only to properly grounded mains
receptacles supplying the voltage indicated on the
rating plate.
Devices certified in compliance with Protection Class
I must be operated on properly earthed power
sources.
In high-humidity environments, such as bath
installations, the unit may be operated only in
conjunction with an approved protective ground-
fault circuit interruptor. Please obtain the advice of an
electrical specialist.
The unit must be operated with the power supply cord
or cable as specified by the manufacturer. No
substitutions are permitted. Observe the
maintenance instructions. Refer to the Operating
Instructions for part number and original equipment
designation.
Never touch the power plug with wet hands.
The power cord and/or extension cord must not be
subjected to of mechanical damage by vehicle tyres,
or to lateral or longitudinal distress (squeezing,
pinching or pulling).
The extension cord must have the cross-section
specified in the Operating Instructions, and must be
spray-water protected. The cable coupling must not
be placed in water.
When replacing couplings on power or extension
cords, the splash protection and mechanical strength
must be maintained. Observe the maintenance
instructions.
Operating Specifics
Prior to each use, the unit and its attachments must
be inspected for proper condition and operational
SC 1502
safety. If the unit is found to be in unsatisfactory or
unsafe condition, its use is prohibited.
Please check especially the safety catch and the
electrical power connection.
The steam hose must be free of damage (scalding
hazard!). A damaged steam hose must be replaced
without delay. Only hoses and connecting elements
approved by the manufacturer may be used.
Refer to the Operating Instructions for order number
and original equipment designation.
Never fill the boiler with solvent-bearing liquids or
undiluted acids! This particularly includes cleaning
agents, petrol or paint thinner. EXPLOSION HAZARD!
Also, do not use acetone, undiluted acids and
solvents, because they attack the materials of which
the unit is constructed.
In the event that the unit is used at petrol stations and
in other hazardous areas, the appropriate safety
regulations must be observed. Operation of the unit
in explosive environments is prohibited.
Never use the appliance in pools containing water.
The unit must be placed securely on a firm surface.
During operation, the steam control switch must not
be wedged open.
Use extreme caution when filling water into the boiler
while it is still hot. Sudden steam pressure could expel
hot water from the boiler and cause severe scalding
injury!
Cleaning of electrical appliances
When cleaning electrical appliances (including electric
cookers), they must be cut off from the mains (switch
off circuit breakers or remove the fuse). Before
returning them to normal operation, the appliances
must be allowed to dry thoroughly. Please observe
the instructions of the respective appliance
manufacturers!
Steam cleaning is prohibited on all electrical
appliances, i.e., hair dryers, electrical heaters, etc.
that allow direct steam contact with electrical wiring
and switches. The steam could enter into the electrical
components and, on condensing, cause an electrical
defect.
Never touch the steam jet with your hand, or direct it
at persons or animals (scalding hazard).
English – 17