Mitsubishi Electric WS-48515 Owner's Manual page 87

Appendix G, continued: Diamond Shield™ Removal for
Models
WS-48515, WS-55515, WS-55615, WS-55615A, WS-65515,
WS-65515A WS-65615, WS-65615A
For the WS-55615, WS-55615A, WS-65615 and
WS-65615A:
1. Snap open the molding clips on the right and
left side of the screen. The side closest to the
screen opens. Unsnap the top, bottom and middle,
preferably in that order (the clips are fixed to the TV
and are not detachable). Do not force the clips, they
should open easily. Proceed to steps 2-4.
Clips are shown
lighter for clarity
Open
molding
clip
������� ���
������� ����
Step 1. WS-55615, WS-55615A, WS-65615 and WS-65615A
Diamond Shield molding clip removal
Closed
molding
clip
For WS-48515, WS-55515, WS-55615, WS-55615A,
WS-65515, WS-65515A WS-65615, WS-65615A
2. To remove the Diamond Shield, slide it out of the
channels, starting with the top. Gently bow the
Diamond Shield towards you and push the top out
of the channel, then lift straight up to remove it from
the bottom channel.
3. Wipe off any dust with a lint-free cloth and store the
shield carefully where it will not be scratched. This
completes the Diamond Shield removal.
Step 2. Diamond Shield removal
4. Re-install the molding clips for a finished look, by
pushing them back into place, starting at a corner.
Do not use force.
To install the Diamond Shield, reverse the process for
your model.
87