V-Chip Lock Menu - Mitsubishi Electric WS-48515 Owner's Manual

V-Chip Lock Menu

V-Chip
Select V-Chip to Block or Allow programs based upon
rating signals sent by the broadcaster. The TV comes
from the factory with the V-Chip Lock in the Off setting.
You can turn the V-Chip On within the V-Chip Menu or
you can use the V-CHIP button on the remote control to
conveniently turn the V-CHIP On or Off.
The factory preset is TV-PG for TV ratings or PG for
movie ratings, allowing only programs rated TV-PG/PG
or lower. You can change the blocking level to various
TV ratings and lettered categories or movie ratings.
After changing channels or devices, there may be up to
a 5 second delay before the V-Chip lock takes effect.
IMPORTANT
If you forget your four-digit
Passcode, see Appendix A.
Entry
Figures 22 and 23
You will see the screen shown in Figure 22 when you
select the V-CHIP submenu from the Main menu, or
after you have canceled your passcode. To use the
Lock, input a four-digit passcode with the number
buttons on the remote control, then press ENTER. You
can delete a number and move back one space by
pressing CANCEL. You can exit without inputting a
passcode by pressing MENU or HOME.
After setting a passcode, the V-Chip Lock is active.
The next time you select V-Chip Lock you will see
"...enter your passcode" instead of "...enter a new
passcode".
������ ������ ����
�� �� �� ��� ����� ����� � ��� ���������
��� ��� ������ ������� ��� ����� ������
Figure 22. V-Chip Entry screen
� � � �
To view a V-Chip blocked program or to watch the
program during a scheduled lock time, you must
enter your 4-digit passcode or change the channel
to an unlocked program. Once you have entered
the passcode, the V-Chip block or Lock by Time will
remain released until the TV is powered Off and then
On again.
������� �� �������
������ ������ ��� ������� ������� ��� ������ ��
����� ����
�� ����� ��� �������� ����� ���� ���������
��� ��� ������ ������� ��� ����� ������
Figure 23. V-Chip Passcode screen
V-Chip Start Time and V-Chip Stop
Time
Figure 24
Select the times you would like the V-Chip to be active.
By setting the V-Chip Start Time and V-Chip Stop Time
to the same time, the V-Chip will be active 24 hours a
day.
Press ADJUST or to slowly select the time,
starting with the hours. Press and hold ADJUST
to quickly select the hours, press ENTER to select
the minutes.
Figure 24. V-Chip Menu, Start & Stop Time
� � � �
or
65