Table of Contents
Advertisement
7 7 7 7 7
Press SHOT button to take a picture.
Check the brightness of image.
If the brightness is not improved, repeat the steps
get the best setting.
2 2 2 2 2
ADJUSTING THE COLOUR OF IMAGE (WHITE BALANCE)
Default setting is flash light W.B. If you are not satisfied with this
setting, please proceed as follows.
1 1 1 1 1
Place a piece of white paper in front of the camera and
display it to cover the LCD.
Place white paper at the actual position where the subject would
normally sit.
Do not display the picture with non-white objects when adjusting
white balance.
Adjust white balance under sufficient light.
2 2 2 2 2
Press SHOT button with flashing a strobe light to take a
picture.
3 3 3 3 3
Press WB button.
White balance adjustment mode is selected.
4 4 4 4 4
Press UP or DOWN button to select LOCK.
5 5 5 5 5
Press SET button for about 5 seconds until white balance
is locked.
NOTE
2
6
to
to
a piece of
white paper
actual distance of a person
who is taking a picture
camera
5 sec.
15
Advertisement
Table of Contents
