Mitsubishi WD-73CLL Supplemental Owner's Manual page 32

32 Appendices
Appendix B: Troubleshooting, continued
TV Power On/Off
Symptom Remarks
2. You cannot program the TV to turn on auto-
3. TV turned itself off and the light on the front
panel started to blink.
puter does.
• Momentary power fluctuation can cause the TV to turn off
to prevent damage. Wait for the green light to stop flashing
and turn the TV on again.
• If the TV does not stay on, press the POWER button on the
control panel for ten seconds to perform System Reset. If
this happens frequently, obtain an AC line power condi-
tioner/surge protector.
• An unusual digital signal may have been received, triggering a
protection circuit. Wait for the light to stop flashing and turn TV
4. TV will not power off.
Symptom
1. The picture does not look like a high-defini- Not all signals are high-definition signals. To receive high-defini-,
tion picture, tion programming from your cable or satellite provider, you must
subscribe to the provider's high-definition service. Some over-
the-air broadcasts are in high-definition and can be received with
Press MENUon the remote control. If the menu displays,
then there is a problem with the incoming signal.
• Check that all video inputs are plugged in firmly.
• Press and hold the POWER button on the control panel for ten
seconds to perform System Reset.
i
3. You cannot view a picture when playing a Check your VCR's owner's guide for further troubleshooting.
VHS tape. ,
up and down. provide on-screen menus at only half-resolution that may
5. When viewing a stopped VCR, white lines • Turn off video mute for the VCR.
are rolling on the screen. • Begin playing the tape.
Change the VCR input from Line 1 to the VCR antenna input.
..... PeiieciCoioi coior b aiance has been incorreciiy sit: et ...........
the PerfectColor balance.
8. The image from a computer appears dis- • Normal TV operation. The TV does not correct distortion in
totted when viewed on the TV. the picture from a computer because the correction process
may cut off the edges of the image.
The aspect ratio may be wrong for the image. Press FORMAT
to change.
For assistance call 1(800} 332-2119