Subaru Impreza 2004 Service Manual page 50

2. TRANSMISSION REAR CROSSMEMBER
AND REAR CUSHION RUBBER
1) Install the rear cushion rubber.
Tightening torque:
39 N·m (4.0 kgf-m, 29 ft-lb)
2) Install the crossmember.
Tightening torque:
T1: 35 N·m (3.6 kgf-m, 26 ft-lb)
T2: 70 N·m (7.1 kgf-m, 51 ft-lb)
T 2
3) Remove the transmission jack.
4) Install the heat shield cover. (If equipped)
5) Install the front, center, rear exhaust pipes and
the muffler. (Non-turbo model)
<Ref. to EX(H4SOw/oOBD)-7, INSTALLATION,
Front Exhaust Pipe.>, <Ref. to EX(H4SOw/oOBD)-
10, INSTALLATION, Rear Exhaust Pipe.> and
<Ref. to EX(H4SOw/oOBD)-11, INSTALLATION,
Muffler.>
6) Install center and rear exhaust pipes, and muf-
fler. (Turbo model)
<Ref. to EX(H4DOTC)-10, INSTALLATION, Center
Exhaust Pipe.>, <Ref. to EX(H4DOTC)-14, IN-
STALLATION, Rear Exhaust Pipe.> and <Ref. to
EX(H4DOTC)-15, INSTALLATION, Muffler.>
C: INSPECTION
Repair or replace parts if the results of the inspec-
tion below are not satisfactory.
1. PITCHING STOPPER
Make sure that the pitching stopper is not bent or
damaged. Make sure that the rubber is not stiff,
cracked, or otherwise damaged.
2. TRANSMISSION REAR CROSSMEMBER
AND REAR CUSHION RUBBER
Make sure that the crossmember is not bent or
damaged. Make sure that the cushion rubber is not
stiff, cracked, or otherwise damaged.
Transmission Mounting System
T 1
T 2
AT-00026
4AT-49
AUTOMATIC TRANSMISSION