Subaru Impreza 2004 Service Manual page 43

AUTOMATIC TRANSMISSION
NOTE:
Plug the opening to prevent an entry of foreign par-
ticles into transmission fluid.
14) Remove the pitching stopper bracket.
15) Set the ST.
ST1 41099AA010 ENGINE SUPPORT BRACK-
ET
ST2 41099AA020 ENGINE SUPPORT
16) Remove the bolt which holds the right upper
side of transmission to engine.
17) Lift-up the vehicle.
18) Remove the under cover.
19) Remove the front, center and rear exhaust
pipe, and muffler. (Non-turbo model)
<Ref. to EX(H4SO)-6, REMOVAL, Front Exhaust
Pipe.>, <Ref. to EX(H4SO)-10, REMOVAL, Rear
Exhaust Pipe.> and <Ref. to EX(H4SO)-12, RE-
MOVAL, Muffler.>
Automatic Transmission Assembly
AT-00680
ST1
ST2
AT-02380
AT-00106
20) Remove the center and rear exhaust pipes,
and muffler. (Turbo model)
<Ref. to EX(H4DOTC)-9, REMOVAL, Center Ex-
haust Pipe.>, <Ref. to EX(H4DOTC)-14, REMOV-
AL, Rear Exhaust
EX(H4DOTC)-15, REMOVAL, Muffler.>
21) Remove the heat shield cover. (If equipped)
22) Drain ATF to remove the ATF drain plug.
(A) Oil pan
(B) Drain plug
23) Disconnect the ATF cooler hoses from pipes of
transmission side, and remove the oil charge pipe.
24) Remove the propeller shaft.
<Ref. to DS-16, REMOVAL, Propeller Shaft.>
25) Remove the shift select cable. <Ref. to CS-13,
REMOVAL, Select Cable.>
26) Disconnect the stabilizer link from transverse
link.
27) Remove the bolt securing ball joint of trans-
verse link to housing.
4AT-42
Pipe.> and <Ref.
AT-00682
(B)
(A)
AT-02389
AT-00683
to