Subaru Impreza 2004 Service Manual page 47

AUTOMATIC TRANSMISSION
23) Tighten the installing bolts. (Sedan model)
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
24) Install the stabilizer link to transverse link. (Se-
dan model)
Tightening torque:
45 N·m (4.6 kgf-m, 33.2 ft-lb)
25) Install the shift select cable onto select lever.
<Ref. to CS-14, INSTALLATION, Select Cable.>
26) Install the oil charge pipe, and connect the ATF
cooler hoses to pipe.
27) Install the propeller shaft.
<Ref. to DS-17, INSTALLATION, Propeller Shaft.>
Automatic Transmission Assembly
AT-00809
AT-00810
AT-00683
4AT-46
28) Install the heat shield cover. (If equipped)
29) Install the rear exhaust pipe and muffler as-
sembly.
Non-turbo model
<Ref. to EX(H4SO)-10, INSTALLATION, Rear Ex-
haust Pipe.> and <Ref. to EX(H4SO)-12, INSTAL-
LATION, Muffler.>
2.0 L Turbo model
<Ref. to EX(H4DOTC)-14, INSTALLATION, Rear
Exhaust Pipe.> and <Ref. to EX(H4DOTC)-15, IN-
STALLATION, Muffler.>
30) Install the front and center exhaust pipe. (Non-
turbo model)
<Ref. to EX(H4SO)-7, INSTALLATION, Front Ex-
haust Pipe.>
31) Install the center exhaust pipe. (Turbo model)
<Ref. to EX(H4DOTC)-10, INSTALLATION, Center
Exhaust Pipe.>
32) Install the under cover.
33) Lower the vehicle.
34) Install the ATF level gauge.
35) Connect the following connectors.
(1) Transmission harness connectors
(2) Transmission ground terminal
36) Install the air cleaner case stay.
Tightening torque:
16 N·m (1.6 kgf-m, 11.6 ft-lb)
37) Install the air cleaner case or air intake cham-
ber. (Non-turbo model)
<Ref. to IN(H4SO)-5, INSTALLATION, Air Cleaner
Case.>
AT-00682
AT-00693